Load data for .30 PICRA + .308 | 150gr | Barnes TSX FN

Recommended Powder(s): none

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.308 \| 150gr \| Barnes TSX FN
Manufacturer SKU:	30334
Bullet Weight:	150gr \| 9.7g
Bullet Diameter:	0.308" \| 7.82mm
Bullet Length:	1.075" \| 27.3mm
Caliber:	.30 PICRA load data
Case Length (l3):	1.291" \| 32.8mm
Cartridge Length (C.O.L.):	2.172" \| 55.2mm
Seated Depth:	0.194" \| 4.9mm
Shank Seated Depth:	0.194" \| 4.9mm
Case Capacity:	24.2 Grains of Water \| 1.57 cm³
Primer Size:	Small Pistol (SP)
Max. allowed Pressure:	40611 psi \| 2800 bar
LID:	LID_B612_C311
Last updated:	2025-01-01

Load data for 54 loads in caliber .30 PICRA with .308 | 150gr | Barnes TSX FN bullet and 27 powders such as none. The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	73%	35940	89%	**70	100%
ADI APS 450	<<locked>>	64%	36492	90%	**60	100%
Accurate 4100	<<locked>>	73%	35679	88%	**55	91%
[Accurate No. 11 FS]*	<<locked>>	83%	36390	90%	**68	84%
Accurate No. 9	<<locked>>	63%	36100	89%	**42	96%
Accurate TCM	<<locked>>	62%	35288	87%	**32	97%
Alliant 2400	<<locked>>	69%	35099	86%	**42	93%
Alliant BLUE DOT	<<locked>>	73%	36187	89%	**39	99%
[Hodgdon H110]*	<<locked>>	77%	35273	87%	**68	87%
Hodgdon LilGun	<<locked>>	78%	34867	86%	**04	94%
Hodgdon TrailBoss	<<locked>>	94%	24555	60%	**9	100%
Lovex D037.2	<<locked>>	62%	36100	89%	**42	96%
Maxam CSB 1	<<locked>>	63%	34838	86%	**15	100%
Ramshot Enforcer	<<locked>>	69%	34867	86%	**52	94%
ReloadSwiss RS 14	<<locked>>	95%	23960	59%	**2	100%
ReloadSwiss RS 30	<<locked>>	94%	35679	88%	**11	91%
SNPE Vectan A0	<<locked>>	63%	35331	87%	**58	100%
SNPE Vectan BA6 1/2	<<locked>>	95%	34983	86%	**42	96%
SNPE Vectan BA7 1/2	<<locked>>	68%	36492	90%	**34	100%
Shooters World Heavy Pistol	<<locked>>	62%	36100	89%	**42	96%
[Somchem S265]*	<<locked>>	86%	36230	89%	**42	87%
Vihtavuori 3N38	<<locked>>	69%	35650	88%	**02	100%
Vihtavuori N105	<<locked>>	72%	35259	87%	**16	100%
Vihtavuori N110	<<locked>>	86%	34809	86%	**62	94%
Vihtavuori N32C Tin Star	<<locked>>	77%	34403	85%	**24	100%
Vihtavuori N350	<<locked>>	64%	36289	89%	**34	100%
[Winchester 296]*	<<locked>>	76%	34737	86%	**75	83%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	61%	26223	65%	**32	100%
ADI APS 450	<<locked>>	61%	34026	84%	**27	100%
[Accurate 4100]*	<<locked>>	61%	23438	58%	**38	83%
[Accurate No. 11 FS]*	<<locked>>	78%	31125	77%	**96	81%
Accurate No. 9	<<locked>>	61%	34360	85%	**16	95%
Accurate TCM	<<locked>>	61%	33547	83%	**06	96%
[Alliant 2400]*	<<locked>>	61%	26803	66%	**98	88%
Alliant BLUE DOT	<<locked>>	61%	25657	63%	**61	95%
[Hodgdon H110]*	<<locked>>	67%	24845	61%	**88	80%
[Hodgdon LilGun]*	<<locked>>	61%	18971	47%	**93	81%
Hodgdon TrailBoss	<<locked>>	60%	13431	33%	**2	100%
Lovex D037.2	<<locked>>	61%	34360	85%	**16	95%
Maxam CSB 1	<<locked>>	60%	32358	80%	**89	100%
Ramshot Enforcer	<<locked>>	61%	26629	66%	**07	90%
ReloadSwiss RS 14	<<locked>>	62%	13416	33%	**5	100%
[ReloadSwiss RS 30]*	<<locked>>	79%	23714	58%	**84	81%
SNPE Vectan A0	<<locked>>	61%	33040	81%	**35	100%
[SNPE Vectan BA6 1/2]*	<<locked>>	63%	14895	37%	**2	80%
SNPE Vectan BA7 1/2	<<locked>>	61%	30414	75%	**58	100%
Shooters World Heavy Pistol	<<locked>>	61%	34360	85%	**16	95%
[Somchem S265]*	<<locked>>	75%	27050	67%	**88	81%
Vihtavuori 3N38	<<locked>>	61%	28123	69%	**94	99%
Vihtavuori N105	<<locked>>	61%	25411	63%	**61	100%
[Vihtavuori N110]*	<<locked>>	63%	17506	43%	**27	80%
Vihtavuori N32C Tin Star	<<locked>>	60%	24221	60%	**6	100%
Vihtavuori N350	<<locked>>	61%	33968	84%	**11	100%
[Winchester 296]*	<<locked>>	72%	30008	74%	**02	80%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data